Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 209 / 448

Settings 16
Setting the working height of the pick-up 16.1
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en 209
16.1.1 Setting the depth limiter
BPG000-070
I Increasing the working height II Reducing the working height
Limiting the lowering of the pick-up
ü
The machine is shut down and safeguarded, refer to page 26 .
ü
The working height of the pick-up is set, refer to page 208 .
„
Open the guard (3).
„
Remove the linch pin (2) and the disc.
„ In order to protect the guide wheels and the pick-up from damages, push the depth limiter
(1) as far as possible in direction position (I).
„
Secure the depth limiter (1) with the disc and the linch pin (2).
„
Check if the depth limiter (1) is in the same position on both sides of the pick-up.
Crop collection without using guide wheels
ü The machine is shut down and safeguarded, refer to page 26 .
„
Slightly raise the pick-up via control unit ( ).
„ Switch off the tractor engine, remove the ignition key and take it with you.
„
Open the guard (3).
„ Remove the linch pin (2) and the disc.
„
Set the height of the pick-up by moving the depth limiter (1) so that the guide wheels will not
be used.
„ Secure the depth limiter (1) with the disc and the linch pin (2).
„
Check if the depth limiter is in the same position on both sides of the pick-up.
„ Close the guard (3).
„ In order to lower the pick-up, move the control unit ( ) into float position.