Maintenance
11
Lubrication Chart
11.2
Bellima F 130
Original Operating Instructions 150000148_06_en
89
11.2
Lubrication Chart
NOTICE
Damage to bearing points
When using lubricating greases not approved and when mixing different lubricating greases,
the lubricated parts may be damaged.
Only use approved lubricating greases,
Do not use graphite-containing lubricating greases.
Do not mix different lubricating greases.
NOTICE
Environmental damage caused by consumables
If consumables are not stored and disposed of properly, they may escape into the
environment. As a result, the environment will be damaged, even by small quantities.
Store the consumables in suitable containers according to the statutory provisions.
Dispose of used consumables according to statutory provisions.
The information on maintenance intervals is based on average load of the machine. In case of
an increased load and under extreme working conditions, the time periods must be reduced.
The types of lubrication are marked by means of icons in the lubrication chart, refer to table.
Type of lubrication
Lubricant
Comment
Grease
Multi-purpose grease
Apply two strokes of
lubricating grease from the
grease gun per grease
nipple.
Remove excess lubricating
grease at the grease nipple.
Oils
Plant-based oils, unless spe-
cified otherwise.
Apply the oil evenly.
