Operation
8
Holding-down clamp
8.10
Bellima F 130
Original Operating Instructions 150000148_06_en
63
The raking height of the pick-up drum (1) is set behind the side guard. The setting must be
identical on the right-hand and left-hand machine side.
KRONE recommends a distance between tines and ground of
20-30 mm
.
For the "Hydraulic connection for tailgate and pick-up" version:
Actuate the control unit
at the tractor (red, 1+) until the pick-up is raised.
For the "Additional hydraulic connection for pick-up" version:
Actuate the control unit
at the tractor (yellow, 3+) until the pick-up is raised.
Make the following settings equally on the right-hand and left-hand side of the machine:
Pull the linch pin (2) out and insert it in the desired position in the perforated bar (3).
Check that the setting of the relief springs (4) is identical on both the right-hand and left-
hand machine side.
INFORMATION
With crops laying very flat on the ground, it may be necessary to have the pick-up run on the
guide wheels only. In this case, the working height is adjusted to the lowest setting.
If the pick-up fails to pick the crops up well even in the lowest working height setting, adjust
the drawbar height,
.
8.10
Holding-down clamp
8.10.1
Setting the lower holding-down clamp
The lower holding-down clamp controls the crops during intake via the pick-up. This ensures
controlled intake of the crops.
RP000-154
Setting the height of the holding-down clamp
swath size
Chain (2)
Holding-down clamp (3)
Much crops
Attach the chain (2) to a
shorter position.
The holding-down clamp (3)
hangs higher.
Sparser crops
Attach the chain (2) to a
longer position.
The holding-down clamp (3)
hangs lower.
ü
The machine is shut down and safeguarded,
.
Make the following settings equally on the right-hand and left-hand side of the machine:
Attach the chain (2) to the support (1) in correspondence with the swath, as shown in the
table.
