Krone Bellima F 130, Оригинальная инструкция по эксплуатации

Страница: 44 / 134

6 Initial operation
6.5 Universal shaft
44
Bellima F 130
Original Operating Instructions 150000148_06_en
RP000-073
In order to reach this optimum drawbar height, the drawbar (1) can be mounted in the top
hitching [I] or in the bottom hitching [II].
ü
The machine is shut down and safeguarded, refer to page 24 .
„
To change the hitch of the drawbar (1), remove the screw connections (4) on both sides of
the drawbar (1).
„ Turn the drawbar (1) by 180° around the longitudinal axis and mount it on both sides of the
drawbar (1) using the screw connections (4).
„
Ensure that the screw connections in the round holes are tightened first and then the screw
connections in the oblong holes (3), tightening torque:
refer to page 94 .
„
Connect the machine to the tractor, refer to page 49 . In doing so, leave the machine on the
support jack (2).
„ For a finer adjustment of the drawbar height, loosen the screw connection in the oblong
hole (3) on both sides of the drawbar (1).
„
Slightly raise or lower the support jack (2) so that the machine remains in the prescribed
position.
„
Tighten the screw connection in the oblong hole (3) on both sides of the drawbar (1).
6.5 Universal shaft
6.5.1 Adjusting the length of the universal shaft
NOTICE
Changing the tractor
The machine could be damaged if the universal shaft length is not checked when changing
the tractor.
„ In order to avoid damage to the machine, check universal shaft length every time the
tractor is changed and correct it, if necessary,
refer to page 45 .