Disturbance, cause and remedy
12
Setting the twine guide at the starter roll
12.5
Bellima F 130
Original Operating Instructions 150000148_06_en
119
Disturbance:
Too much crops material remains on the bale ejector. On bale ejection, this crops
material is ejected together with the bale.
Possible cause
Remedy
The setting of the bale ejector
is too low.
Set the bale ejector higher,
12.5
Setting the twine guide at the starter roll
RP000-188
If the twine is not received or the twine coil is basically not working, the twine guide must be
checked and adjusted on the starter roll.
The 2 twines (5) must run in the centre of the respective pressure roll (3) on the starter roll (2)
(as shown).
ü
The machine is shut down and safeguarded,
.
Loosen the counter nuts (4) at the double eyelet bolt (1).
Set the height of the double eyelet bolt (1) in such a way that the two twines run centrally to
the respective pressure roll (3) at the starter roll (2).
Set the inclination of the double eyelet bolt so that twines (5) rest against both sides of the
eyelets.
Tighten the counter nuts (4).
12.6
Setting the cutting unit of the twine tying unit
WARNING
Risk of injury due to sharp blades at the cutting unit of the tying unit
You may injure your fingers and hands when inserting the wrapping and tying material or
working in the range of the cutting unit of the tying unit.
Always wear protective gloves when inserting the wrapping and tying material and when
working in the range of the cutting unit.
When working in the range of the cutting unit, work particularly carefully and prudently.
