Maintenance
11
Checking and adjusting the twine tying unit
11.8
Bellima F 130
Original Operating Instructions 150000148_06_en
101
11.8.2
Checking and adjusting the starter roll and the pressure rolls
RP000-138
Rotate the starter roll (1) slightly in order to check whether the pressure rolls (3) rotate
easily.
If the pressure rolls (3) fail to rotate smoothly:
Push a screwdriver between the drive roll (1) and pressure rolls (3) and lightly move from
left to right.
If necessary, loosen the screw connection (2) and oil the bearing positions.
11.8.3
Cleaning the cutting unit
WARNING
Risk of injury due to sharp blades at the cutting unit of the tying unit
You may injure your fingers and hands when inserting the wrapping and tying material or
working in the range of the cutting unit of the tying unit.
Always wear protective gloves when inserting the wrapping and tying material and when
working in the range of the cutting unit.
When working in the range of the cutting unit, work particularly carefully and prudently.
RP000-190
The cutter blades (5) must be freely movable. Corrosion and soiling may restrict the movability
of the cutter blades (5).
Clean the blade guides (2).
Loosen the screws (1) and move the cutter blades (5) until they run smoothly once more.
Tighten the screws (1) only so far that the cutter blades (5) still run smoothly.
