Krone 870 HDP, Оригинальная инструкция по эксплуатации, Страница: 278 / 568

Settings
278
Pos: 93.83.9 /Ü berschriften/Ü berschriften 3/P-T/S/Seitliche Pr esskolbenmesser einstell en @ 354\mod_1438244783253_78.docx @ 2645866 @ 3 @ 1
19.14.2 Setting the Lateral Plunger Blades
Pos: 93.83.10 /BA/Ei nstellungen/Gr oßpackenpr esse/Presskol beneinstellung/Seitliche Pr esskolbenmesser einstellen Bil d 1290 HD P II / 870 / 4x4 @ 3 54\mod_1438178311737_78.docx @ 2645226 @ @ 1
X
1
Fig. 201
1) Plungers 3) Screw
2) Lateral plunger blades 4) Bale channel wall
The lateral plunger blades are set equally for left-hand and right-hand side of plungers. The
procedure described below to set the lateral plunger blades therefore applies to both sides of
the plungers.
• To secure the plungers (1), tighten flywheel brake.
• Measure the dimension X between lateral plunger blades (2) and bale channel wall (4) at the
narrowest point.
If the dimension is X=3-5 mm at the narrowest point, the lateral plunger blades (2) are
correctly set.
If the dimension is not X=3-5 mm at the narrowest point, the lateral plunger blades (2)
must be set.
• Loosen the screws (3).
• Set dimension
X=3-5 mm
.
• Tighten the screws (3).
• Loosen flywheel brake and turn flywheel manually in the working direction.
• To secure the plungers (1), tighten flywheel brake.
If the dimension is X=3-5 mm at the narrowest point, the lateral plunger blades (2) are
correctly set.
If the dimension is not X=3-5 mm at the narrowest point, repeat the process until the
dimension is X=3-5 mm.
Pos: 93.83.11 /Layout M odul e /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1