Krone 870 HDP, Оригинальная инструкция по эксплуатации, Страница: 250 / 568

Settings
250
Pos: 93.1 /Überschriften/Überschriften 1/A-E/Ei nstellungen @ 0\mod_1199868783862_78.docx @ 36141 @ 1 @ 1
19 Settings
Pos: 93.2 /BA/Sicher heit/2. Vor angestellte Warnhi nweise/WARNUNG - Nichtbeachtung der grundl egenden Sicherheitshinweise alte F orm @ 254\mod_1397485793575_78.docx @ 1953347 @ @ 1
WARNING!
If the basic safety instructions are not followed, people may be seriously injured or
killed.
• To avoid accidents, the basic safety instructions in the chapter Safety must have been
read and followed, see chapter Safety "Basic safety instructions".
Pos: 93.3 /BA/Sicher heit/2. Vor angestellte Warnhi nweise/WARNUNG - Nichtbeachtung der Sicherheitsr outinen al te For m @ 273\mod_1404117435996_78.docx @ 2058712 @ @ 1
WARNING!
If the safety routines are not adhered to, people may be seriously injured or killed.
• To avoid accidents, the safety routines in the chapter Safety must be read and followed,
see chapter Safety "Safety routines".
Pos: 93.4 /BA/Einstell ung en/Gr oßpackenpr esseFolgende Ar beitsschritte wer den i n diesem Kapitel beschri eben Bi G PAC K 1290 HD P II @ 325\mod_1425894441756_78.docx @ 2501787 @ @ 1
The following work steps are described in this chapter:
– Setting the working height of the pick-up.
– Setting the ground pressure of the guide wheels.
– Driving with fixed pick-up.
– Setting the holding-down device.
– Setting the lateral needles.
– Checking / setting the needle yoke brake.
– Checking / setting the position needles - baling ram.
– Checking / setting the upper needles.
– Checking / setting the twine bars.
– Checking / setting the twine bars to the channel slot.
– Checking the overreach of the twine bars at the second knot.
– Tensioning / releasing the upper needle.
– Tightening / releasing the twine bar shaft.
– Setting the knotter shaft brake.
– Setting the twine brake.
– Setting the knotters.
– Setting the baling ram.
– Setting the packer to the baling ram.
– Checking the packer coupling.
– Setting the Variable Filling System.
– The default setting of flywheel brake.
– Setting the cutting length, in case of full equipping of blade cassette
– Setting the cutting length, depending on the blade fitting in the blade cassettes.
Pos: 93.5 /Layout M odul e /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1