KRONAsteel KIRSA 500, Лист приложения

Страница: 7 / 24

5
EN Application sheet EN Application sheet
KITCHEN HOODS
Do not install the filter in the kitchen hood until it is
completely dry. The filter is installed in the reverse
order. Press the spring lock on the filter and put it in
place, after which release the lock.
Installation of carbon filters
For your hood, two coal filters are installed.
They are mounted on the protective grilles of the
motor duct by lightly pressing and turning them
clockwise. To remove the carbon filter, it should be
slightly squeezed and turned counter-clockwise
(Fig. A).
Replacing the backlight
To replace the backlight, it is necessary (see Fig.
B) to:
– disconnect the hood from the power supply and
find the burned out lamp wire;
– disconnect the power cable in the connector
by pressing the two lobes of the hood plafond,
removing the burned out lamp
– insert a new one into the place of the burned out
backlight;
– connect the lamp power lead in the connector;
– connect the hood to the mains and check the
operation of the backlight.
HOOD INSTALLATION
INSTRUCTION
Only the specialist has the right to install
and connect the hood to the mains.
You can not start the installation of the hood and
remove the protective film from the stainless steel
hood until you are convinced of the technical
condition of the hood by connecting it to the
electrical network and checking all its functions.
To do this, open the package, remove the hood
and place it on a flat surface in such a way that
switch of operating modes is turned towards the
inspector. The hood is then connected to the
mains and being tested.
If it is working properly at all modes, then you
should start installing the hood. If not, contact the
organization where you purchased the hood or the
warranty workshop. Protective film from stainless
steel hoods should only be removed after the hood
has been installed.
We remind you that the height of the hood
above the electric stove should be at least 65
cm, and above the gas stove less than 75 cm.
It is recommended to install this hood together
with one more person.
Before installing the hood, make sure that the wall
on which the hood is hung is competent enough.
To hang the hood and the bracket for securing the
decorative duct, use screws and dowels, which
suit the type of walls in your kitchen (reinforced
concrete, plasterboard, etc). If the screws and
dowels are included in the kit, you should make
sure that they are suitable for the type of wall on
which the hood will be hung.
Install the hood in the following sequence:
1. Before starting to drill the holes for the dowels
in the wall, markings must be made. Place the
hood bracket horizontally on the wall so that
when the hood is stretched to it, the necessary
distance to the table top is obtained. Make a
marking of the holes for fixing the bar (Figure
8.1). 2. Drill a hole of the required diameter. The
depth of the hole must correspond to the length
of the dowel.
3. Screw the installation bar into the drilled places
(figure 8.1).
4. Install the plastic adapter flange (if not installed)
by fixing it.
5. Hang the hood body on the reference points A
and B according to the attached figure (Figure
8.2).
6. If the hood is operated in the mode of exhausting
air to the ventilation shaft, one end of a flexible
duct with a diameter of 120 mm is required (a
flexible duct with a length of 1 m, if longer, it
is purchased separately) is to be put on the
adapter flange, preliminary smear it with sealer
and secure it with a clamp (available separately).
(Figure 8.3) We remind you that you can not use
a duct with a smaller diameter than 120 mm.
The second end of the flexible duct must be
connected to the ventilation hole in the wall. It