Kromek D3S Static Node, Руководство пользователя

Страница: 7 / 28

MAL-OPS-0970 Version 1.0 Page 7 of 28
Never short-circuit the positive and negative terminals of a
battery or charge, disassemble, apply deforming pressure,
or expose the battery to fire.
The D3S Static Node contains HAZARDOUS LIVE parts.
The device must be installed with an external breaker so that
power can be disconnected as required.
The D3S Static Node contains HAZARDOUS LIVE parts.
External power must be disconnected before opening the lid
as this could expose HAZARDOUS LIVE parts.
The wiring specification is designed for standard single
phase 16A Mains supply. If the device is to be installed in a
situation that does not have 16A current limitation, then a
current limiting device must also be installed rated to 16A.
The D3S Static Node contains HAZARDOUS LIVE parts.
Follow all instructions outlined in the Installation section of
this manual. Special care must be used to use the anchor
points for the mains cable to prevent risk of electrical shock.
3 Precautions
3.1 Precautions for Safe Use
The following precautions should be observed to ensure that the product is being
used safely:
•
Do not use the product in environments subject to inflammable, explosive,
or corrosive gases.
•
Do not disassemble, repair, or modify the product in any way.
•
Tighten the base mounting screws and terminal block screws securely.
•
Use the specified sizes of crimp terminals for wiring.
•
Always use cable restraints and anchor points where available.
•
Confirm that the input voltage to be applied is within the rated power supply
voltage (115V AC ± 10%, 50-60Hz or 230V AC ± 10%, 50-60Hz.) before
using it.
•
Do not allow water to enter the case. Fire or electric shock may result
•
Always disconnect the power supply before opening the case.