7
User – Settings
5
Turn the rotary knob clockwise.
▷
The desired temperature selection is displayed, flashes.
6
Press the OK button.
▷
The desired night-time room temperature flashes.
7
Use the rotary knob to select the desired night-time temperature.
▷
The temperature can be set in 0.5 °C increments.
8
Press the OK button to confirm.
▷
The new desired temperature is displayed.
9
Turn the rotary knob clockwise.
▷
The desired hot water temperature is displayed flashes.
10
Press the OK button.
▷
The warm water value flashes.
11
Use the rotary knob to set hot water value.
▷
The temperature can be set in 1 °C increments.
12
Press the OK button to confirm.
▷
The new hot water temperature is displayed.
1
Finally, turn the selector switch back to
.
Display actual temperatures
1
Turn selector switch to
.
2
Use the rotary knob to set one of the following temperature
displays.
AF
Outside temperature
*)
Heat source temperature
*)
Flow temperature
*)
Hot water temperature
* The relevant desired temperature is displayed when the OK button is
pressed.
▷
If a sensor is not connected, the display will show
-- --
.
▷
The display reverts to the standard indication after a few seconds
without action.
Set operating mode
The operating mode determines how the heating controller works.
Whether the heating system is to be controlled automatically or man-
ually, during a party for example. Or how should the heating system
be controlled during longer periods of absence such as holidays?
▷
The heating controller leaves the factory with the setting
Standby/OFF. The operating mode must be changed for nor-
mal operation.
You can set the following operating modes
Standby/OFF
Heating and hot water preparation are deactivated. Only the frost
protection function remains active.
1 Automatic mode 1
Heating occurs according to heating program 1: Heating occurs
at identical times for Monday–Friday, as well as Saturday–Sunday.
Hot water according to parameter 04, see page 8 (Set heating
program 1).
2 Automatic mode 2
Heating occurs according to heating program 2: You can set Individual
heating times for each day. Hot water according to parameter 04,
see page 9 (Set heating program 2).
▷
Toggling between Automatic mode 1 and 2 can be useful for
shift workers. The times do not need to be entered for each
shift - they only need to be switched over.
Day mode
24 hour heating with desired daytime room temperature, see page 6
(Set the desired temperature). Hot water according to parameter 04