Kress Robotik Mission NANO, Руководство пользователя

Страница: 15 / 26

15
EN
and store this additional wire in a separate location. It is important to leave the necessary length where it
connects to the charging base so it can be connected and still remain buried.
7.2 Burying the Boundary Wire
If you are planning to bury the boundary wire, it is recommended to first peg it down. This allows you to easily
change the layout if necessary before burying the wire. When the boundary wire installation is complete, have
MissionNANO™ follow and check the path by pressing
and . This will allow MissionNANO™ to
adjust to its new environment.
While observing MissionNANO™ you can easily make alterations to the boundary wire to ensure the
MissionNANO™'s trouble-free tracking when locating the charging station. Confirm that MissionNANO™
docks in the charging station successfully, and bury the wire if desired.
7.3 Joining the boundary wire
If you want to extend and splice the boundary wire, use a connector. The connector is waterproof and
provides optimal connection.
Insert both wire ends in any two of the three holes of the connector. Insert the wires fully until both wire ends
are visible on the other side of the connector. (See Fig. J1) Press the connector together by using a pair of
pliers. (See Fig. J2, J3)
WARNING: It is not recommended to simply splice the boundary wire with insulating tape or use a screw
terminal block for connection. A broken circuit may occur after a period of time as soil moisture can oxidize
the wire.
8. Software update
The software can be updated when new versions become available. The latest software can be downloaded
from our website
www.kress-robotik.com . There are two methods to update software.
Method 1: Update via USB. See below for download and installation instructions:
1) Locate the latest software version at: www.kress-robotik.com . Save the file to an empty FAT32
formatted USB (flash drive). Delete any other files on the drive and check the format. If the drive is not
formatted in FAT32, please reformat the drive.
NOTE: The software update is downloaded as a zipped file. You will need to unzip or extract it before
proceeding.
2) Place MissionNANO™ on a secure and level surface. Turn the main switch to the “O” position to turn off
J1 J2
J3