Krautzberger KS 5, Руководство по эксплуатации, Страница: 21 / 49

n Only operate the hand-held spray gun in compliance with the values specified in the (
Ä
Chapter 11 ‘Technical data’ on page 44 ).
n
Only use accessories from Krautzberger GmbH!
n Only use sufficiently sturdy hoses! Check and, if necessary, replace older hoses before
starting up the hand-held spray gun.
n Only use hoses that match the hose connections and check them for their proper seat and
ensure that they are leak-proof.
n It is recommended to flush the hand-held spray gun prior to start-up using a suitable cleaning
agent (spraying process with cleaning product, until it runs clear when exiting).
n To ensure that there are no particles clogging the nozzles, we recommend to clean the
coating material with a material filter positioned in front of the fluid connection (high pressure
material filters can be purchased from Krautzberger GmbH).
n
To achieve a unified coating thickness for high-quality coatings, a cross-coating process is
recommended, which means that the area is first coated in horizontal lines and then in vertical
lines.
In contrast to compressed air-operated hand-held spray guns, the spray pattern for airless
devices can by default not be changed through settings on the nozzle. If a different spray pat-
tern is desired, the airless-nozzle must be exchanged. When adjustable fluid nozzles are
used, you can adjust the spray angle.
Among other factors, the spray pattern depends on the viscosity of the coating material. It can
be modified through the material pressure. If the optimal application cannot be achieved
through material pressure changes, it is recommended to try again with a different fluid
nozzle.
5.3 Start-up
5.3.1 Preparation
1. Attach fluid nozzle (
Ä
Chapter 6.6 ‘Replace valve seat screw and fluid nozzle’
on page 37 ).
2. Establish ground connection for the hand-held spray gun.
3. Connect pressure hose to the fluid connection.
4. Provide the coating material and accessories for the material supply.
5. Switch on fluid pump.
6. Regulate the material pressure with the regulator.
7. Open the shut-off valves at the material source.
Hand-held Spray Gun KS 5
ENGLISH
■ 200-0368 GB–21