Krautzberger 090-3566, Руководство по эксплуатации

Страница: 5 / 61

1 Function and identification
1.1 Function
The hand-held spray gun Mignon 3 is used for the coating of surfaces with liquid to low-viscose
coating materials. Typical coating materials are: Paints, dyes, adhesives, glazes, enamels,
debonding agents.
The coating material is fed to the hand-held spray gun either under pressure (fluid pressure pumps
or pressurised fluid containers to process large quantities of coating material) or through attached
gravity feed cups or suction cups (for smaller quantities).
Begin spraying process by pulling the trigger. The spraying process is terminated by releasing the
trigger.
The coating material is atomised using compressed air.
The geometry of the spray jet and the sprayed quantity of the coating material can be adjusted:
n Selection of various air and fluid nozzles
n Changing of the atomiser air pressure
n
Changing of the coating material pressure
n Adjustment of the needle stroke on the regulator of the hand-held spray gun
n
Adjustment of the flat jet regulator on the hand-held spray gun
The hand-held spray gun Mignon 3 is available in different designs:
Supply of coating material:
n via attached gravity feed cups or suction cups holding from 65 to 300 ml
n
via hose lines on the gun handle
n via hose lines on the head section
The hand-held spray gun consists of the following materials: Aluminium (head section), stainless
steel (needle and nozzle) as well as brass and plastic (seals).
Gravity feed cups and suction cups are made of aluminium, copper or plastic.
Before starting up the hand-held spray gun, check the compatibility of the device materials
with the coating materials that are used!
Hand-held Spray Gun Mignon 3
ENGLISH
200-0137 ￭ 200-0138 ￭ 200-0187 ￭ 090-3566 ￭ 200-0155 ￭ 200-0156 GB–5