8 Maintenance
8.1 Safety
Personnel:
n
Operator
n
Qualified personnel
Protective equipment:
The selection of the protective equipment depends on the maintenance conditions on site and the
medium utilized by the system owner. The applicable country-specific safety, accident prevention,
occupational safety, and environmental protection regulations must adhered to for the proper
selection of the protective equipment and the information given by the spray media manufacturer
on the safety data sheet must be taken into consideration.
WARNING!
Risk of injury through the use of incorrect spare parts!
The use of incorrect or defective spare parts can cause hazards for the personnel as well as
damage, malfunctions or complete failure.
–
Only use OEM parts from Krautzberger or Krautzberger-approved spare parts.
–
In case of questions, always contact our Customer Care department.
8.2 General maintenance information
The spray gun is not subject to any regular maintenance intervals.
Wear parts such as seals, nozzles, and needles should be checked in regular intervals and
replaced if necessary for trouble-free operation. The level of wear depends on the abrasiveness of
the spray fluid used. Escaping air and spray fluid as well as the deterioration of the spray pattern
are signs that parts are worn.
8.3 Maintenance schedule
Interval
Maintenance work
Personnel
After each use
Clean handheld spray gun (
‘Cleaning the hand-held spray gun’ on page 27
)
Operator
if needed
‘Changing the material nozzle and the air
nozzle’ on page 34
)
Qualified personnel
Change fluid needle (
Change sealing cone (
‘Changing the sealing cone’ on page 36
)
Change O-ring in air connection (
8.8 ‘Changing O-ring in air connection’
on page 38
)
Operating instructions
T-Dok-198-GB-Rev.3
[email protected], www.krautzberger.com
GB–26
Содержание 090-3566
Страница 60: ......
