Kramer Electronics Ltd.
VS-622DT
– Changing the Device Settings
31
Changing Ethernet Settings when DHCP is Off
After changing the
Mask address
, you need to power cycle the
VS-622DT
.
To change the Ethernet settings:
1. In the Navigation pane, click
Device Settings
. The Device Settings page appears.
2. Click the
Communication
tab:
Figure 28: Device Settings Page
– Communication Tab
3. If DHCP is OFF, change any of the parameters (IP Address, Netmask and/or Gateway).
4. Click
Set
.
Figure 29: Device Settings Page
– Communication Warning
5. Click
OK
.
The page with the new settings is reloaded.
6. If required, change the TCP/UDP port number.
7. Click
Set
.
The port number has changed.
