Kramer Electronics Ltd.
UHD Matrix Switcher
– Operating VS-88UHD via Front Panel Buttons
24
Setting the Switching Mode
Set the following
switching modes separately for each output:
•
Manual mode (
IN 1
): inputs are switched to outputs via the front panel buttons.
•
Priority mode (
IN 2
): the
VS-88UHD
switches the source with the highest priority to the
output.
•
Last connected mode (
IN 3
): the last detected active source is switched to the output.
To select the switching mode:
1. Press
RCL
and
MUTE/PATTERN
simultaneously. Both buttons illuminate.
2. Press an output button (or press
ALL
).
The corresponding 7-segment display LEDs flash and
LOCK
button flashes.
3. Press
IN 1
,
IN 2
or
IN 3
.
4. Press
LOCK
to save the settings to that output and exit Switching mode.
Setting the Switching Speed
Set the following switching speed modes separately for each output:
•
Extra-Fast switch speed (
IN 1
).
•
Fast switch speed (
IN 2
).
•
Normal switch speed (
IN 3
).
To select the switching speed:
1. Press
STO
and
MUTE/PATTERN
simultaneously. Both buttons illuminate.
The 7-segment display LEDs show the current switch speed for each port.
2. Press an output button (or press
ALL
).
The corresponding 7-segment display LEDs flash and
LOCK
button flashes.
3. Press
IN 1
,
IN 2
or
IN 3
.
4. Press
LOCK
to save the settings and exit Speed mode.
Setting HDCP
You can enable or disable HDCP for each of the HDMI inputs.
To set HDCP on or off:
1. Press and hold
EDID
and
RCL
until both buttons illuminate.
The IN buttons indicate the HDCP status:
▪
HDCP enabled (on): IN button is illuminated.
▪
HDCP disabled (off): IN button is off.
