Kramer Electronics Ltd.
UHD Matrix Switcher
– Operating VS-88UHD via Front Panel Buttons
14
Switching the Video and the Audio Signal Simultaneously
You can select the digital audio signal to switch to the output together with the video signal.
To switch the audio and video signals together to an output:
1. Press
D-AUDIO
and
VIDEO
simultaneously.
The button illuminates and the 7-segment display
shows the current IN-OUT video
status.
2. Press an
OUT (MUTE)
button (1 to 8).
The 7-segment display LED, under the selected output, flashes.
Press
ALL
(instead of an output button) to route the selected input to all the outputs.
All the 7-segment display LEDs flash.
3. Press an
IN (PATTERN)
button (1 to 8).
The selected video and audio input is switched to the selected output (or to all the
outputs if
ALL
was pressed instead) and the 7-segment display shows the current
status.
Switching the Video Signal
The
VIDEO
button on the
VS-88UHD
front panel enables video routing.
To switch a video input to an output:
1. Press
VIDEO
.
The button illuminates and the 7-segment display
shows the current IN-OUT video
status.
On the front panel buttons:
•
An illuminated input button means that an active signal is detected on that input.
•
An illuminated output button means that a display is connected to that output.
•
A flashing output button means that a non-HDCP display is connected to that
output.
Note that in case an HDCP-encrypted input is routed through the matrix to a
non-HDCP screen, the video will not be presented and the non-HDCP screen will
turn black.
On the 7-segment display:
•
A digit (from 1 to 8) shows the input number that is currently routed to the output.
•
“
P
” under an output number indicates that a pattern is routed to that output.
•
“
0
” under an output number indicates that the output is muted.
2. Press an
OUT (MUTE)
button (1 to 8).
The 7-segment display LED, under the selected output, flashes.
Press
ALL
(instead of an output button) to route the selected input to all the outputs.
All the 7-segment display LEDs flash.
3. Press an
IN (PATTERN)
button (1 to 8).
The selected input is switched to the selected output (or to all the outputs if
ALL
was
pressed instead) and the 7-segment display shows the current status.