Kramer Electronics Ltd.
VS-34FD
– Input / Output Card Hardware Installation Instructions
31
Input / Output Card Hardware
Installation Instructions
VS-34FD
input and output cards mount in one of the 17 slots on the rear of the
VS-34FD
chassis. Slots are numbered from left to right according to the number of the ports on each
card. For example, slot one is numbered 1
–2 because the card in that slot contains inputs or
outputs 1 and 2.
VS-34FD
slots are interchangeable, meaning that an input or an output card
can be inserted into any slot.
You can insert IN/OUT cards into slots while the device is powered.
The process for inserting cards is the same for all cards. The diagram below is for illustration
purposes only.
To install an input / output card:
1. Power off the machine and all devices connected to it.
2. Use a Phillips screwdriver, loosen the screws at the top and bottom of the blanking plate.
3. Remove the blanking plate from the slot and store it for possible future use.
4. Remove the new card from its shipping box and anti-ESD bag.
5. Holding the card by the lower handle, align the card with the plastic guide rails.
6. Slide the card into the chassis until the front of the card contacts the connector inside the
chassis.
7. Press the card firmly into the slot until the connector plate is flush with the rear panel of
the chassis and the connector is fully seated.
8. Using a Phillips screwdriver, tighten the retaining screws at the top and bottom of the
card to secure it to the chassis.
9. Power on
VS-34FD
and configure the new card using the embedded web pages.
10. Power on the peripheral devices.
Figure 27: Input / Output Card Installation
