Kramer Electronics Ltd.
VS-34FD
– Operating and Controlling – Front Panel
14
Changing Action Confirmation Mode
VS-34FD
enables you to configure whether an action needs to be confirmed before the
system executes it. By default, switching is executed in At Once mode, in which actions are
implemented immediately upon pressing the relevant buttons. In Confirm mode, after pressing
the relevant buttons, the TAKE Button flashes, and the action are not implemented until you
press the TAKE Button.
At Once mode is the default for all actions except storing and recalling presets, where the
default is Confirm mode.
Failure to press the TAKE Button within a few seconds results in the action timing out.
To change the action confirmation mode:
•
Press the TAKE Button
.
The action confirmation mode changes.
If the TAKE Button is flashing, you cannot change the confirmation mode.
Switching
–
Front Panel
VS-34FD
enables you to switch inputs to outputs using the Numeric Keypad
.
The following rules apply when using the Numeric Keypad:
•
When entering a single digit number (for example 5), you can either press 0 followed by
5, or 5 followed by the ENTER Button
.
•
Pressing 00 (or 0, ENT) is only relevant for an input and is used to disconnect the
currently entered output number from the input.
•
The ESC Button
is used to cancel an operation without affecting the current status.
For example, if you enter an incorrect number by mistake, press the ESC Button
to
cancel the operation.
•
At any stage, if no button is pressed within approximately 15 seconds, the automatic
timeout causes
VS-34FD
to exit the operation and revert to the output/input display.
VS-34FD
enables you to do the following:
•
•
•
Switching an Input to All Outputs
•
•
•
12
1
9
8
8