Kramer Electronics Ltd.
VS-1616DN-EM
– Protocol 3000
122
Protocol 3000
The
VS-1616DN-EM
2x2 to 16x16 Modular Multi-Format Managed Digital Matrix Switcher
can be operated using the Kramer Protocol 3000 serial commands. The command framing
varies according to how you interface with the
VS-1616DN-EM
. For example, a basic video
input switching command that routes a layer 1 video signal to HDBT out 1 from HDMI input 2
(
ROUTE 1,1,2
), is entered as follows:
•
Terminal communication software, such as Hercules:
The framing of the command varies according to the terminal communication software.
•
K-Touch Builder (Kramer software):
•
K-Config (Kramer configuration software):
All the examples provided in this section are based on using the K-Config software.
You can enter commands directly using terminal communication software (e.g., Hercules) by
connecting a PC to the serial or Ethernet port on the
VS-1616DN-EM
. To enter CR press the
Enter key (LF is also sent but is ignored by the command parser).
Commands sent from various non-Kramer controllers (e.g., Crestron) may require special
coding for some characters (such as,
/X##
). For more information, refer to your controller’s
documentation.
