Kramer Electronics Ltd.
TP-594Txr, TP-594Rxr
– Connecting the TP-594Txr
10
Connecting a Balanced/Unbalanced Stereo Audio
Source to the Analog Audio Balanced Input
The following are the pinouts for connecting a balanced or unbalanced stereo audio source to
the balanced analog audio input:
Figure 6: Connecting a Balanced Stereo Audio
Source to the Balanced Input
Figure 7: Connecting an Unbalanced Stereo Audio
Source to the Balanced Input
Connecting to TP-594Txr / TP-594Rxr via RS-232
in this section,
TP-594Txr
is taken as an example (
TP-594Txr
and
TP-594Rxr
connect to
RS-232 ports in the same way).
You can connect to the
TP-594Txr
via an RS-232 connection
using, for example, a PC.
The
TP-594Txr
features an RS-232 3-pin terminal block connector allowing the RS-232 to
control the
TP-594Txr
or for signal-extension over HDBT.
Connect the RS-232 terminal block on the rear panel of the
TP-594Txr
to
a PC/controller, as
follows:
From the RS-232 9-pin D-sub serial port connect:
•
Pin 2 to the TX pin on the
TP-594Txr
RS-232 terminal
block
•
Pin 3 to the RX pin on the
TP-594Txr
RS-232 terminal
block
•
Pin 5 to the G pin on the
TP-594Txr
RS-232 terminal block
RS-232 Device
TP-594Txr
13
DRAFT
