PT-12 Quick Start
P/N:
2 9 0 0 - 3 0 1 0 2 0 QS
Rev: 5
Scan for full manual
PT-12 Quick Start Guide
This guide helps you install and use your
PT-12
for the first time.
www.kramerav.com/downloads/PT-12
to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check w
hat’s in the box
PT-12
HDMI Controller
4 Rubber feet
1 Bracket set
1 Power adapter and cord
1 Quick start guide
Step 2: Get to know your PT-12
#
Feature
Function
1
SERVICE Mini USB Connector Connect to a PC/laptop running EDID Designer to modify the EDID, control
PT-12
via
P3K protocol or to update its firmware.
2
IN LED
Lights green when an HDMI active signal source is connected to the input.
3
OUT LED
Lights green when an HDMI acceptor is connected to the output.
Flashes three times upon successful load of the designed EDID and then resumes to
normal operation.
4
ON LED
Lights green when power is connected.
5
HDMI
®
IN Connector
Connect to an HDMI source.
6
HDMI
®
OUT Connector
Connect to an HDMI acceptor.
7
SETUP DIP-Switches
Set the device behavior, defined in the DIP-switch setup table.
8
5V DC Power Connector
Connect to the supplied power adapter.
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
Step 3: Install PT-12
Install
PT-12
using one of the following methods:
•
Attach the rubber feet and place the unit on a flat surface.
•
Fasten a bracket (included) on each side of the unit and attach it to a flat surface.
For more information go to
www.kramerav.com/downloads/PT-12
•
Mount the unit in a rack using the recommended rack adapter
www.kramerav.com/product/PT-12
