Kramer KDS-DEC7, Руководство пользователя

Страница: 18 / 114

Kramer Electronics Ltd.
KDS-EN7, KDS-DEC7
– Operating and Controlling KDS-EN7
15
3. Change channel number using arrow buttons:
▪
For the KDS-EN7 set a unique channel number.
▪
For each of the KDS-DEC7 devices, set to the defined KDS-EN7 channel number.
4. Press Enter to save your selection.
To set the channel number via web pages:
1. Connect the KDS-EN7 / KDS-DEC7 Ethernet port to the network and power the device.
2. Access the embedded web pages.
3. In the Main page:
▪
For KDS-EN7 :

Go to AV Routing page.

Select Channel ID and define the channel ID number.
▪
For KDS-DEC7 :

Go to AV Routing page.

Select Channel ID (corresponding to the desired encoder channel ID).
By default, KDS-EN7 and KDS-DEC7 are DHCP-enabled. This section describes how to
operate via the Ethernet and access the IP address when DHCP is enabled and when a static
IP address is used.
You can connect to KDS-EN7 via Ethernet using either of the following methods:
•
When DHCP is enabled (see, for example, KDS-EN7 Network Settings on page 30 ).
When using a static IP Address (DHCP is disabled):
•
Directly to the PC using a crossover cable (see Connecting Ethernet Port Directly to a
PC on page 16 ).
•
Via a network hub, switch, or router, (using a static IP address) using a straight-through
cable (see Connecting Ethernet Port via a Network Hub on page 18 ).
Note : If you want to connect via a router and your IT system is based on IPv6, speak to your
IT department for specific installation instructions.
Accessing the Web UI
By default, IP setting for KDS-7 Decoders is DHCP.
To access the Web UI, perform the following:
1. Connect the LAN port of the device to a local area network.
Make sure that there is a DHCP server in the Network so that the device can obtain a
valid IP address.
2. Connect your PC to the same network as the device.