60
K-CONFIG - The Driver Manager – Getting Started
You can also do this logarithmically, for example, to increase the volume at a fast rate in the lower range and slower in
the higher range:
•
Check Logarithmic.
•
Select the approximate number of steps you need (the table calculates the optimal number).
•
Click the Set button.
Figure 97: The Driver Manager Window – Logarithmic Row Selection
8.
Set the LED Level:
Figure 98: The Driver Manager Window – Setting the LED Levels
The Levels indicate the number of digital knob LEDs that light for each data command on relevant room
controller devices (for example, the
RC-63DL
or
RC-54DL
). You can set the LEDs to light only in sequence.
For example, one LED will light for data commands up to 30. Two LEDs will light up to data command 50, and
so on.
