Kramer FC-132ETH, Руководство пользователя, Страница: 31 / 61

FC-132ETH - Operating the FC-132ETH Remotely via the Web Pages 27
9.6 Serial Port Settings Page
The Serial Port Settings page allows you to set the parameters that will be used
when the port is switched to an Ethernet port and also allows you to:

Set the following Ethernet parameters for each of the 33 serial ports. These
parameters must be used to address the serial port form and Ethernet host:

Select TCP or UDP

IP port label

TCP keep alive time: 0-3600sec (default 60sec) time internal, after-
which detected idle connection is disconnected

Set the following serial parameters for each serial port. These parameters must
be used when data arrives at the port from an Ethernet connection using the
above-mentioned Ethernet settings:

Parity

Data bits

Baud rates

Stop bits
Note : When switched to one of the local 1-8 serial inputs, these settings are not
used).

Select whether or not to send replies on the port to the new client