Kramer FC-132ETH, Руководство пользователя

Страница: 15 / 61

FC-132ETH - Initial Configuration and Use Overview 11
6.1 Configuring the FC-132ETH
To configure the FC-132ETH :
1. Connect the Ethernet port on the rear panel of the FC-132ETH to a PC
either directly (see Section
‎7.2
) or via a LAN.
2. Using a Web browser, (see Section
‎9
and Section
‎11
) browse to the General
Info home page (see Figure 10 ).
3. Click on Device Settings to browse to the Device Settings page, (see
Figure 13 ).
4. Enter the time and date manually, or enter the Time server address for
automatic time and date synchronization.
5. Click Save Changes.
6. Click on Communication to browse to the Communication page, (see
Figure 14 ).
7. Enter the IP address, mask and gateway for static IP addressing and Click
Set.
—Or—
Click DHCP On for dynamic IP addressing.
Note : If you have changed the IP from the default setting, you must reload
the General Info home page again using the new IP address.
8. Click on Serial Ports Settings to browse to the Serial Port Settings page,
(see Figure 15 ).
9. Associate the required serial ports with their corresponding TCP/UDP
settings.
10. For each associated serial port, enter the serial port configuration
parameters using the drop-down lists under Serial Configuration.
11. Click Save Changes.