DSP-62-AEC
Quick Start
P/N: 2 9 0 0 - 3 0 1 3 6 3 QS
Rev: 1
Scan for full manual
DSP-62-AEC Quick Start Guide
This guide helps you install and use your
DSP-62-AEC
for the first time.
www.kramerav.com/downloads/DSP-62-AEC
to download the latest user manual and check if
firmware upgrades are available.
Step 1: Check
what’s in the box
DSP-62-AEC
Digital Sound Processor
1 Kramer
C-USB/AB-6
cable
4 Rubber feet
1 Power adapter and cord
1 Quick start guide
1 Bracket set
Step 2: Get to know your DSP-62-AEC
#
Feature
Function
1
SETUP DIP-switches
Set DIP-switch 4 to ON to upgrade the firmware, OFF (default) for normal
operation (other DIP-switches are reserved for future use).
2
HDMI IN 1 Button
Press to select HDMI IN 1 input (on the front panel).
3
HDMI IN 2 Button
Press to select HDMI IN 2 input (on the rear panel).
4
AUDIO LEDs
USB IN
Lights green when an audio source is received from the USB host port.
USB OUT
Lights green when an audio signal is sent to the USB host port.
5
IN (1 to 5)
Lights green when a signal is present, lights red when clipping is detected.
For IN 2 to IN 5, when connecting a microphone and setting to Mic mode via
the embedded Web pages, lights blue.
OUT
Lights green when a signal is present, lights red when clipping is detected.
6
AUDIO IN 3.5mm Mini Jack
Connect to an unbalanced audio source.
7
USB Type B Bi-Directional Host Port
Connect to an audio source or acceptor.
8
HDMI IN 1 Connector
Connect to an HDMI source.
9
ON LED
Lights green when the device is powered.
10
HDMI IN 2 Connector
Connect to an HDMI source.
11
HDMI
™ OUT Connector
Connect to an HDMI acceptor.
12
AUDIO IN 3-pin Terminal Block Connectors
(2 to 5)
Connect to up to 4 mono balanced audio sources (mono or mic level with
selectable 48V).
13
AUDIO OUT 5-pin Terminal Block Connector
Connect to a stereo balanced audio acceptor.
14
I/O Terminal Block Connectors (1 to 2)
Connect to up to two sensors, switches, LEDs, or relays.
15
RS-232 (G, Rx, Tx) Terminal Block Connector Connect to a PC/serial controller
16
ETHERNET
RJ-45 Connector
Connect to a PC via a LAN.
17
RESET Recessed Button
Press and hold while powering the device to reset to factory default values,
including IP settings.
18
12V DC Power Connector
Connect to the power supply and to the mains electricity.
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
