#SP41-50A Log Set Installation
SECTION 8
FIREPLACE SETUP
#SP-41-L
R.6 February 2022
34
HUSSONG MFG. CO., INC.
KOZY HEAT FIREPLACES
8.2 #SP41-50A Log Set Installation
CAUTION: Do not place logs directly over burner port holes. Improper
log placement may affect flame appearance and cause excessive soot
to build upon the logs and glass.
•
If converting to propane, complete the conversion before
installing the log set. Follow the conversion instructions included
with the kit.
•
Log numbers are located on the bottom of each log. Refer to the
following instructions and illustrations for proper log placement.
1. Place log SP41-1A on the back log plate.
2. Place log SP41-2A on the left front log plate.
3. Place log SP41-3A on the right front log plate.
4. Distribute lava rock in front of the burner. Do not block burner
ports or airspaces.
5. Align log SP41-4A with the notches on logs SP41-1A and SP41-
2A, as shown.
6. Align log SP41-5A with the notches on logs SP41-1A, SP41-2A,
and SP41-3A, as shown.
7. Align log SP41-6A with the notches on logs SP41-1A and SP41-
3A, as shown.
8. Use a steel or stiff bristle nylon brush to distribute rock wool
embers onto logs and burner. DO NOT block the area as
shown below.
DO NOT distribute rockwool in this area
FIGURE 8.2
Completed Install
FIGURE 8.1
Base Logs
