34 FIREPLACE SETUP
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
#SP-34 LE & MV R.5 January 2020
8.2 #SP34-50A Log Set Installation
CAUTION: Do not place logs directly over burner port holes. Improper
log placement may affect flame appearance and cause excessive soot
to build upon the logs and glass.
•
If converting to propane, complete the conversion before
installing the log set. Follow the conversion instructions included
with the kit.
•
Log numbers are located on the bottom of each log. Refer to the
following instructions and illustrations for proper log placement.
1. Place log SP34-1A on the back log plate.
2. Align the holes in log SP34-2A with the mounting pins on the left
front log plate. Push log down to seat.
3. Align the holes in log SP34-3A with the mounting pins on the
right front log plate. Push log down to seat.
4. Align log SP34-4A with the notches in logs SP34-1A and SP34-2A
as shown.
5. Align log SP34-5A with the notches in logs SP34-1A, SP34-2A,
and SP34-3A as shown.
6. Align log SP34-6A with the notch in log SP34-3A and place as
shown.
7. Distribute lava rock in front of the burner. Do not block burner
ports or airspaces.
8. Distribute rockwool embers onto the logs and burner using a
stiff bristle brush. DO NOT block the area as shown below.
Figure 8.1, Base Logs
Figure 8.2, Installed Set
DO NOT distribute rockwool in this area.
