GAS FIREPLACE INSERT SETUP
29
Hussong Mfg. Co., Inc. Kozy Heat Fireplaces
#NDK-34-i R.1 July 2022
9.4
#NK34-500 Log Set Installation
CAUTION: Do not place logs or klinkers directly over burner port holes.
Improper log and klinker placement may affect flame appearance
and may cause excessive soot to build upon the glass.
•
If converting to propane, complete the conversion before
installing the log set. Follow the conversion instructions included
with the kit.
•
Log numbers located on the bottom of each log. Refer to the
following instructions and illustrations for proper placement.
1. Remove media tray/log rack (4) screws. Remove (2) screws securing
light kit, set light kit to the side. Loosen (2) 7/16” nuts securing
left and right burners. Remove burners.
2. Install refractory panels. Follow instructions included with the kit.
3. Place log #N34-1 and log #N34-2 on corresponding pins on burner
(not shown). Be sure to place N34-1 and N34-2 logs BEFORE
placing glass media. Logs must lie flat on media tray and burners.
Failure to do so will negatively affect the flame.
4. Fill back media tray with crushed glass media
5. Place log # N34-3 onto log # N34-1 aligning hole in the bottom of log #
N34-3 with the corresponding pin on log #N34-1.
6. Reinstall left burner assembly pushing it towards center until it stops
against the rear burner, then secure. Repeat this process with the
right burner assembly.
7. Reinstall light kit and media tray/log rack.
8. Install log #N34-4 and #N34-5 aligning holes in bottom of logs with
corresponding pins on burners.
9. Place log #N34-6 and Klinkers on burner ensuring burner ports are not
covered.
10. Fill front media tray with crushed glass media. Fill void on either side
of media tray with lava rock.
11. Place log #N34-7 along log rack.
12. Place Klinkers on crushed glass media on front media tray.
13. Use a stiff or steel bristle brush to distribute rockwool embers onto the
burner and logs. Use ONLY up to ½ the bag, save the rest for later use.
Do not place
glass media
in this area
