17
9.4
CXL2-500 Log Set
CAUTION
Do not place the logs directly over the burner port holes. Improper log placement may affect flame appearance and cause excessive
soot to build up on the glass.
If converting to LP (propane) gas, complete the gas
conversion before log set installation. Follow the
conversion instructions included with the kit.
Log numbers are located on the bottom of each log.
1. Position the ember panel 2CX in front of burner as shown in
Figure 9.5.
2. Align the two (2) holes in the bottom of log 1CX with the two
(2) mounting pins at the back of the burner. Push the log
down onto the pins to seat. See Figure 9.6.
3. Align the holes on the bottom of logs 3CX and 4CX with the
mounting pins on burner. Push the logs down onto the pins
to seat. See Figure 9.6.
4. Align logs 5CX and 6CX with the notches on logs 1CX and
3CX. See Figure 9.7.
5. Align log 7CX with the notches in 1CX, 4CX, and the ember
panel 2CX. See Figure 9.7
6. Align log 8CX with the notches in 1CX and 4CX. See Figure
9.5.
Figure 9.5, Logs 1CX and 2CX
1CX
2CX
Figure 9.6, Logs 3CX and CX4
3CX
4CX
Figure 9.7, Logs 5CX, 6CX, 7CX and 8CX
8CX
7CX
6CX
5CX