#CLW-ST R.1 February 2021
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
FRAMING
21
Exterior structure
The overhang (A) must be a minimum of 1/2 or
greater of the roofline elevation (B) above the
base of the fireplace.
The width of the overhang to each side of the appliance (C)
must be a minimum of 1/2 or greater of the roofline elevation (B)
above the base of the fireplace.
EXAMPLE: If roofline (B) is 10’ (3m) above the base of fireplace, the overhang (A) must be
5’ (1.5m) or greater. The width of the overhang to EACH side of the fireplace (C) must be 5’ or greater.
A
B
C
C
A
B
Figure 3.11, Outdoor Covered Fireplace Install - 1
3.7 Outdoor Covered Fireplace Installation
IMPORTANT: This fireplace allows for outdoor covered installation and
an indoor-outdoor partition (see CWST-ODK manual included with
the kit). Outdoor covered installation should be used when you desire
the fireplace to be a significant source of heat in an outdoor area. An
indoor-outdoor partition will not be a significant source of outdoor
heat as the fireplace heat will radiate to the interior of the home.
An outdoor covered fireplace installation allows a fireplace to be
installed in an outdoor covered area, where the appliance is protected
from direct precipitation.
Based on your design options and installation choices (standard
installation, vented cavity, or Komfort Zone Kit), follow your specific
requirements pertaining to your installation.
Follow the instructions and illustrations on this page and the
following page for installation procedures.
3.7.1 Safety Screen Barriers
Hussong Mfg. Co., Inc. highly recommends to use black painted
safety barriers in outdoor installations. Other screen barriers that
incorporate a plated or patina finish are highly susceptible to
oxidation and discoloration.
3.7.2 Requirements
•
The continuous insulated building envelope and weatherproof
membrane are not to be interrupted by fireplace installation. See
Figure 3.12 on the following page.
•
Fireplace operation is approved from 40°F to 110°F.
•
All wiring connections shall be in accordance with outdoor
requirements of NECA NFPA 70.
•
All clearances and requirements in your appliance manual must
be adhered to.
ALL DESIGN OPTIONS INSTALLATION
