#BAY-41-LE R.5 July 2019
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
FIREPLACE SETUP
39
8.0 FIREPLACE SETUP
8.1 Glass Frame Assembly
WARNING: Do not operate this fireplace with the glass removed,
cracked, or broken. Replacement of the glass assembly, should be done
by a licensed or qualified service person.
8.1.1 Remove Glass Frame Assembly
WARNING: Do not remove the glass assembly when hot.
1. Remove safety barrier.
2. Locate (2) spring-loaded latches securing the glass assembly at
the bottom of the firebox.
3. Pull the spring-loaded latches out and down to release the
bottom of the glass assembly.
4. Lift glass assembly up and off of the (2) tabs located at the top of
the firebox.
8.1.2 Install Glass Frame Assembly
1. Align the slots on top of the glass assembly over the tabs at
the top of the firebox while lowering the bottom of the glass
assembly into position.
2. Pull the spring-loaded latches out and up to secure the bottom
of glass to the bottom of the fireplace.
3. Reinstall safety barrier.
8.2 Bottom Frame Removal
and Installation
To access the control module housing, the bottom frame will need to
removed. It must be reinstalled after servicing to maintain clearances .
1. Remove the safety barrier.
2. Locate the bottom frame.
3. Lift the bottom frame up and out of slots on firebox floor.
4. To reinstall, align the tabs on the bottom frame and lower into
position.
5. Reinstall safety barrier.
Figure 8.1, Bottom Louver Removal
