#BAY-41-LE R.5 July 2019
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
FACING AND FINISHING
23
4.4 Safety Barrier Installations
4.4.1 Inside Fit - Recessed Installation
Model #B41-RSF2
1. Center the screen front over the glass frame assembly, allowing
the screen front’s notched tabs to fit inside the air openings.
2. Align the notched tabs (located on the back) with the slots in the
air openings. Raise the screen front slightly and push back into
position.
3. Lower the screen front until the notched tabs are firmly in
position.
4. Insert the upper hood into the clips located at the top of the
upper air passage. Note: this will be a fairly tight fit.
•
To remove safety screen: lift the screen up and out of slots.
UPPER HOOD
SCREEN FRONT
Figure 4.7, #B41-RSF2 Installation
4.4.2 Overlap Fit - Hanging Installation
IMPORTANT: If there is gasket rope present on the back on the safety
screen, ensure the gasket makes contact with the appliance or finishing
material. The gasket MUST maintain contact to achieve the mantel
clearances listed in this manual.
1. Center the screen front over the glass frame assembly, allowing
the screen front’s mounting brackets to fit inside the air
openings.
2. Align the notched tabs (located on the back) with the slots in the
fireplace. Raise slightly and push back to desired position.
3. Lower the screen front until the notched tabs are firmly in
position, verifying the depth accommodates finish material.
•
To remove safety screen: lift the screen up and out of slots.
ALIGN THE NOTCHED TABS WITH
THE SLOTS IN THE FIREPLACE
AND PUSH BACK TO POSITION
THAT ACCOMDATES FINISH MATERIAL
NOTE: THE GASKET ON THE
BACK OF THE FIREPLACE SAFETY
SCREEN FRONT MUST MAKE
CONTACT WITH THE FIREPLACE FACE/
FINISH MATERIAL
Figure 4.8, Side View Gasket Install
