20
FACING AND FINISHING
5.3 Safety Barrier Installations
5.3.1 Inside Fit - Recessed Installation
Model #B41-RSF
1. Locate the slots on the back side of the screen front.
2. Partially thread (4) truss head screws, included with this
assembly, into each mounting hole on the fireplace (2 each
side).
3. Align the slots on the screen front with the truss head screws
on the fireplace, then slide the screen front unto fireplace.
4. Tighten all screws.
• Fireplace accessibility: loosen, but do not remove, the (4)
truss head screws located on the sides of the fireplace. Raise
the screen up slightly and out.
5.3.2 Overlap Fit - Hanging Installation
Models #B41-PSF, #B41-FRSF, #B41R-MSF, #B41A-MSF,
#B41R-CSF, and #B41A-FPDSF.
1. Center the screen front over the glass frame assembly,
allowing the screen front’s mounting brackets to fit inside the
air openings.
2. Align the notched tabs (located on the back) with the slots
in the fireplace. Raise slightly and push back to desired
position.
3. Lower the screen front until the notched tabs are firmly in
position, verifying the depth accommodates finish material.
• To remove safety screen: lift the screen up and out of slots.
5.3.3 Overlap Fit - Direct Mount
Installation Option
Models #B41-PSF, #B41R-MSF, and #B41A-MSF (recommended
for low height clearance applications).
1. Locate the (4) acorn nuts on the left and right side of the
screen front face (2 each side).
2. Remove and save the (4) nuts securing the (2) mounting
brackets to the screen front.
3. Position mounting brackets to fit inside the air openings on
the sides of the fireplace, and align the (2) notched tabs on
the back of each bracket with the slots in the fireplace.
4. Set the mounting brackets into desired position, verifying the
depth accommodates finish material.
5. Secure mounting brackets with (4) truss head screws
(included) into each mounting hole on fireplace (2 each
side).
6. Slide the screen front over the (4) mounting studs and secure
with the (4) side acorn nuts previously removed.
• Fireplace accessibility: remove the (4) acorn nuts on the left
and right side of the screen front face (2 each side), then
remove screen front assembly from studs on the mounting
bracket.
