36
FIREPLACE SETUP
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
#ALP-36 R.7 January 2020
8.4 #AL36-500 Log Set Installation
CAUTION: Do not place logs directly over burner portholes. Improper
log placement may affect flame appearance and cause excessive soot
to build upon the logs and glass.
•
If converting to propane, complete the conversion before
installing the log set. Follow the conversion instructions included
with the kit.
•
Log numbers are located on the bottom of each log. Refer to the
following instructions and illustrations for proper log placement.
1. Align the holes in the bottom of logs #1 through #3 with the
mounting pins on the burner. Push to seat.
2. Position log #4 as shown below.
3. Position logs #5 through #8 over the base logs as shown below,
aligning the pins in logs with the holes in the base logs.
4. Position logs #9 through #11 as shown below. The cutout in the
back of log #10 aligns with the center tine on the log rack.
5. Use a stiff bristle or steel brush to distribute rockwool embers
onto burner and logs.
Figure 8.6, Base Logs
Figure 8.7, Completed Installation
