Korg Nu:tekt OD-KIT, Руководство пользователя

Страница: 12 / 16

- 12 -
Building the Nutube circuit board unit
1. Attach the Nutube rubber (56) to the back side of the Nutube, as
shown in the diagram.
When attaching the Nutube rubber, make sure that it does not touch
the sealing lid of the Nutube.
Nutube
Sealing lid
Nutube rubber
2. Solder the Nutube (47) onto the side of the Nutube circuit board with the
screen-printed surface.
After making sure that all of the Nutube pins have been inserted into
the holes on the circuit board, peel off the release paper on the Nutube
rubber. Mount the rubber so that it is flush with the Nutube circuit
board, and then solder.
3. Solder the connectors.
Nutube
connector
4. Attach the circuit board cushion (57) onto the back side of the
Nutube circuit board.
Nutube circuit board
Circuit board cushion
Nutube circuit board
as-built drawing