Korg NAUTILUS Series, Руководство по параметрам, Страница: 625 / 961

SAMPLING: Page Menu Commands Copy
615
Copy
This command copies the sample data from the area between
the
Start and End points into the sample data buffer. This
data can then be used by the Insert , Mix , or Paste
commands.
When you execute Copy , the data that is copied into the
buffer actually consists only of the source sample number
and the
Start and End locations–not the data itself. Do
not delete the source sample until you finish executing
the
Insert , Mix , or Paste command.
1. Use Sample Select (1–1b) to select the sample that you
wish to edit, and use Start and End to specify the
editing range.
You can press the SAMPLING START/STOP button or
Play button to hear the portion that will be copied by the
Copy command.
2. Select Copy to open the dialog box.
3. The range to be copied is shown by Range Start and
End .
4. To execute the Copy command, press the OK button.
To cancel, press the Cancel button.
Insert
When you execute this command, the sample data placed in
the buffer by executing
Copy in the SAMPLING mode
Sample Edit page will be inserted at the Start address. The
data that follows this address will be moved toward the end
of the sample.
1. Use Sample Select (1–1b) to select the sample that you
wish to edit, and set Start to specify the starting
address. The End setting is ignored.
2. Select Insert to open the dialog box.
3. To Start will indicate the starting address at which the
data will be inserted.
4. In Save to No., specify the save destination sample
number. By default, an unused sample number will be
selected.
If Overwrite is checked, the sample number will be fixed
to the current sample, and cannot be changed. See “About
Overwrite” on page 605.
For stereo samples, use “Save to No.(L)” and
“(R)” to specify the save-destination of the L and R
channels.
5. To execute the Insert command, press the OK button.
To cancel, press the Cancel button.
If the buffer into which data was placed by the Copy
command contains no data, the display will show the
message, “Source sample is empty.”
Mix
When you execute this command, the sample data placed in
the buffer by executing
Copy in the SAMPLING mode
Sample Edit page will be mixed with the selected sample
data, starting at the
Start address.
1. Use Sample Select (1–1b) to select the sample that you
wish to edit, and set Start to specify the starting
address. The End setting is ignored.
2. Select Mix to open the dialog box.
3. To Start will indicate the starting address at which the
data will be mixed.
4. In Save to No., specify the save destination sample
number. By default, an unused sample number will be
selected.
If Overwrite is checked, the sample number will be fixed
to the current sample, and cannot be changed. See “About
Overwrite” on page 605.
For stereo samples, use “Save to No.(L)” and
“(R)” to specify the save-destination of the L and R
channels.
5. To execute the Mix command, press the OK button.
To cancel, press the Cancel button.
If the buffer into which data was placed by the Copy
command contains no data, the display will indicate
“Source sample is empty.”
From the buffer
From the buffer