Korg NAUTILUS Series, Руководство по параметрам, Страница: 261 / 961

STR-1: Tone Adjust 9–9: String Track
251
STR-1: Tone Adjust
STR-1 Tone Adjust Default Settings
Tone Adjust provides an elegant physical interface to the
STR-1’s parameters. Most of the factory sounds use the
default layout, as shown above. You can also customize the
layout for individual sounds, if desired.
For more information about Tone Adjust, please see “0–9a:
Tone Adjust,” on page 29.
STR-1 Tone Adjust parameters
The STR-1 supports all of the Common Tone Adjust
parameters, as described under “0–9a: Tone Adjust,” on
page 29. It also adds a number of its own additional
parameters, which apply only to the STR-1.
Note that these additional parameters are separate for each
EXi, as opposed to being shared by both EXi in the Program.
All of the additional parameters are listed below. Tone
Adjust parameters may affect the internal parameters in one
of two ways: they may be
Relative , in which case they scale
the existing parameter value, or Absolute , in which case
they over-write the existing value. Unless otherwise noted,
all of the STR-1 parameters are
Absolute .
Pluck
• Pluck Type
• Pluck Randomization
• Pluck Delay
• Pluck Width
• Pluck Width AMS1 Intensity
Noise
• Noise Saturation
• Noise Filter Frequency
String
Dispersion
String
Decay String
Nonlinearity
Str Excitation
Position
Str Harmonic
Position
Pickup 1
Position
Pickup 2
Position
String
Damping
Pluck
Width
Pluck
Randomization
Harmonic Pressure
AMS1 Intensity String
Level
PCM Osc
Level
Noise
Level
Pickup 1
Level
Pickup 2
Level
Pluck
Type
Button 7, 8:
LFO1 Stop
LFO2 Stop
Button 15, 16:
LFO3 Stop
LFO4 Stop
Button 1, 2:
PCM Tra12,
String Tra12