Basic Guide
21
Introduction
Front and rear panel
Connections
Playing
Editing
e. Adjust the pitch of oscillator 2 in semitone units
●
Rotate the [SEMITONE] knob.
The LCD screen will show Page 06C: OSC 2 “Semitone.”
The most common way to use this is to set oscillator 2
one or two octaves lower than the pitch of oscillator 1.
f. Adjust the pitch of oscillator 2
●
Rotate the [TUNE] knob.
The LCD screen will show Page 06D: OSC 2 “Tune.”
By slightly skewing the pitch to create a detuning effect,
you can give the sound more depth.
3. Set the volume of each oscillator
a. Adjust the volume of oscillator 1
●
Rotate the MIXER [OSC1] knob.
The LCD screen will show Page 07A: MIXER “OSC 1
Level.”
b. Adjust the volume of oscillator 2
●
Rotate the MIXER [OSC2] knob.
The LCD screen will show Page 07B: MIXER “OSC 2
Level.”
4. Make filter settings
a. Select the filter type
●
Press the [FILTER TYPE] key.
Each time you press the key, the filter type will change,
and the LED of the selected filter type will light.
The filter type will have a major impact on the character
of the sound.
b. Adjust the brightness of the sound
●
Rotate the FILTER [CUTOFF] knob.
The LCD screen will show Page 08B: FILTER “Cutoff.”
Rotating the knob toward the right (increasing the
value) will brighten the sound.
c. Adding character to the sound
●
Rotate the FILTER [RESONANCE] knob.
The LCD screen will show Page 08C: FILTER “Reso-
nance.”
Rotating the knob toward the right (increasing the
value) will dramatically change the character of the
sound.
The resonance effect will also be significantly affected by
the filter type and cutoff settings.
d. Adjusting the depth of the effect from EG1
EG1 changes the filter cutoff over time. “EG 1 Int” adjusts
the depth of this effect.
●
Rotate the FILTER [EG 1 INT] knob.
The LCD screen will show Page 08D: FILTER “EG 1 Int.”
Rotating the knob to the right of center (+ values) will
cause the effect to be applied to the cutoff in the positive
(+) direction.
Rotating the knob to the left of center (– values) will
cause the effect to be applied to the cutoff in the negative
(–) direction.
06C OSC 2
Semitone: -12
06D OSC 2
Tune: +06
a
b
07A MIXER
OSC 1 Level: 127
07B MIXER
OSC 2 Level: 100
a
b
c
d
08B FILTER
Cutoff: 060
08C FILTER
Resonance: 045
08D FILTER
EG 1 Int: +40