44
Button 4 (GLOBAL 4)
These parameters relate to the minilogue’s MIDI capabilities.
MIDI Ch
[1...16]
In order to communicate, the minilogue and your other MIDI devices must be
set to the same MIDI channel. This is both the Transmit and Receive channel.
Clock Source
[Auto (USB), Auto (MIDI), Internal]
Many features of the minilogue can be sync’d to the tempo or BPM. This pa
-
rameter allows you to specify whether the clock source is internal, or an exter
-
nal MIDI Clock Source.
Auto (USB)
,
Auto (MIDI)
: When there is no input, the internal clock will be
used; and when input is detected, the internal clock will be synchronized to the
clocks from the USB B and MIDI IN connectors respectively.
Internal
: Only the internal clock to be used.
When a cable is plugged into the SYNC IN jack, the internal clock is
synchronized to the SYNC IN jack clock, regardless of the MIDI clock
settings.
Enable Rx MIDI
[Off, On]
Set this parameter to ON to allow the minilogue to receive MIDI messages.
Enable Tx MIDI
[Off, On]
Set this parameter to ON to allow the minilogue to transmit MIDI messages.
MIDI Route
[USB+MIDI, USB]
MIDI signals can be sent and received via the MIDI and USB connectors, or by
the USB connector alone.
USB+MIDI
: MIDI messages are received via the USB B connector and the MIDI
IN connector; messages are transmitted from the USB B connector and the
MIDI OUT connector.
USB
: MIDI messages will be transmitted and received only via the USB B con
-
nector. When using the USB connector as a MIDI interface, it is advantageous
to use this setting.
Содержание minilogue
Страница 58: ......
