Korg Electronic Keyboard, Руководство по параметрам

Страница: 765 / 1127

Outputs Main Outputs
755
Outputs
Main Outputs
The main L/MONO and R outputs of the OASYS are
output from the AUDIO OUTPUT (MAIN) L/MONO
and R jacks, the S/P DIF OUT (MAIN) jack, and the
headphone jack.
Individual Outputs
The OASYS is equipped with eight individual audio
outputs, which can be used as individual mono
outputs, stereo pairs, or any combination of the two.
Signals sent to these outputs are also mirrored on the
ADAT outputs of the optional EXB-DI, if installed.
Almost any signal source can be routed to these
outputs, including:
• Each note in a Drum Kit
• Insert Effect outputs
• Each Program in a Combination or Song
• Audio tracks
• Audio inputs
You can use these to isolate or group together sounds
for recording, or for complex live performance setups.
If the signal is going through one or more insert effects,
the output is set at the last IFX in the chain, via the
Bus
Select
parameter on the P8-5 Insert Effects page.
If a Program, Timbre, or Track is not going through any
insert effects, the output is set using the
Bus Select
parameters on the P8-1 or 8-2 Routing page.
To assign audio inputs directly to outputs, use
Bus
Select
parameters in the P0– Audio Input (Sampling)
page.
In Global mode, the Audio page
L/R Bus Indiv. Assign
setting lets you mirror the MAIN stereo L/R output on
any pair of individual outputs. You can use this to
create a private monitoring setup in live and studio
environments, or to send the main outputs to the
optional EXB-DI’s ADAT output. For more
information, see “L/R Bus Indiv. Assign (Assign to
L/R and Indiv.Out)” on page 649 of the Parameter
Guide.
Note: You can’t use the VOLUME slider to adjust the
volume of the individual outputs.