23
Configure the AC+Thin AP mode
The JetWave 2450v2 provides 4 operation modes: “
Thin AP
”, “
Virtual AC
”, “V
irtual AC+Thin AP
”, as
well as “
FAT AP
”. The default mode is “Thin AP”. To allow the JetWave 2450v2 to manage the thin
APs, you need to switch one of the JetWave 2450v2s to virtual controller mode first. To change the
mode, please do the following.
Configure the AC+Thin AP mode
To operate as AC+Thin AP, go to
Basic Settings
. From
Device Mode
drop-down list, select “
Virtual
AC
” mode. If you would like the Access Point to perform as a virtual controller and access point
concurrently, please select “
Virtual AC + Thin AP
” mode. Then assign an IP address to the JetWave
2450v2 and specify subnet mask, gateway and DNS address respectively. Hit
Apply
and wait for
about 50 seconds to take effect.
AC+ Thin AP mode allows the JetWave 2450v2 to operate as access controller and
thin AP concurrently.
To operate as standalone Access Point, wireless client or bridge, please select
FAT
AP
from device mode.
Note:
Note:
