Korenix Technology Co., Ltd.
Industrial
Layer 3 Managed Ethernet Switch
_____________________________________________________________________________
Industrial Layer 3 Managed Ethernet SwitchUser Manual
Page: 41/1568
5.2
CLI Mode-based Topology
Parameters
Parameters are order dependent.
The text in bold italics should be replaced with a name or number. To use spaces as part of a name
parameter, enclose it in double quotes like this: "System Name with Spaces".
Parameters may be mandatory values, optional values, choices, or a combination.
<parameter>. The <> angle brackets indicate that a mandatory parameter must be entered in
place of the brackets and text inside them.
[parameter]. The [] square brackets indicate that an optional parameter may be entered in place
of the brackets and text inside them.
choice1 | choice2. The | indicates that only one of the parameters should be entered.
The {} curly braces indicate that a parameter must be chosen from the list of
choices.
Values
ipaddr
This parameter is a valid IP address, made up of four decimal bytes ranging from 0 to 255.
The default for all IP parameters consists of zeros (that is, 0.0.0.0). The interface IP address of 0.0.0.0 is
invalid.
macaddr
The MAC address format is six hexadecimal numbers separated by colons, for example
00:06:29:32:81:40.
areaid
Area IDs may be entered in dotted-decimal notation (for example, 0.0.0.1). An area ID of
0.0.0.0 is reserved for the backbone. Area IDs have the same form as IP addresses, but are distinct from
IP addresses. The IP network number of the sub-netted network may be used for the area ID.
routerid
The value of <router id> must be entered in 4-digit dotted-decimal notation (for example,
0.0.0.1). A router ID of 0.0.0.0 is invalid.
slot/port
This parameter denotes a valid slot number, and a valid port number. For example, 0/1
represents unit number 1, slot number 0 and port number 1. The <slot/port> field is composed of a valid
slot number and a valid port number separated by a forward slash (/).
logical slot/port
This parameter denotes a logical slot number, and logical port number assigned. This
is applicable in the case of a port-channel (LAG). The operator can use the logical slot number, and the
logical port number to configure the port-channel.
