P R E L I M I N A R Y
29867
.06_01.VC.070319/151238
© 2007 Kontron Modular Computers GmbH
ID 29867.06, Rev. 01
Page 16
CoDeSys PLC
PROGRAMMING ASSISTANCE GUIDE
ThinkIO
™
- P
6.2
PLC Configuration (I/O)
6.2.1
Configuring K-Bus I/O Modules
On the left side of the CoDeSys main display window there is a box called the resources area,
at the bottom of which there are four selection tabs. The right most tab is the
Resources
tab.
The following procedure begins with the selection of this tab.
To add and configure K-Bus I/O modules using the K-Bus configurator, perform the following:
PROCEDURE START:
Configuring K-Bus I/O modules
1. Initial screen (same as in section 6.1, after step 8)
2. Click the
Resources
tab
