KISS
Oil & Gas
2U User’s Manual
www.kontron.com
To install or remove the drives:
1. Remove the chassis drive cover.
2. Unlock the drive bay by Moving the lock counterclockwise (to the left).
3. Push the left side of the drive carrier to release
4. Gently pull open drive bay and insert/replace drive using screws provided
5. Reinsert drive bay by gently push back into the system.
6. Relock drive bay cover.
8.4.
Installing Expansion Cards
Please consider following instruction when you install (or remove) expansion cards.
The installation and removal of expansion cards have to be carried-out only by qualified
specialist personnel in accordance with the description in this manual.
Before removing the device cover, ensure that your system is switched off and
disconnected from the mains power supply.
Please refer to the ESD safety procedures for handling assemblies with static sensitive
devices. Failure to take heed of this warning instruction can result in damage to the device.
Please read information provided by the manufacturer of any expansion cards before
installing them or removing them from your system.
To install or remove an expansion card proceed as follows:
1.
Switch your system off and disconnect it from the main power supply.
2.
Remove the two screws, which secure the cover on the top front of the system.
3.
Pull the cover back and remove it.
4.
Loosen phillips pan-head screw securing each expansion port filler plate.
5.
Slide the expansion port filler plates to the right tightening them temporarily once enough space is made
to install/remove card.
6.
Place the expansion card in or pull it out of the PCI bay on the motherboard and secure the cards
7.
Adjust the expansion card hold down brackets to protect the cards.
8.
Close the device and secure the cover with the screws.
Please read information provided by the manufacturer of any expansion cards before
installing them or removing them from your system.
34