Kontron CP6930-RM, Руководство пользователя

Страница: 25 / 50

Installation
10 CP6930-RM User Guide
www.kontron.com
2 Installation
The CP6930-RM has been designed for easy installation. However, the following standard precautions,
installation procedures, and general information must be observed to ensure proper installation and to pre-
clude damage to the boards, other system components, or injury to personnel.
2.1 Safety Requirements
The following safety precautions must be observed when installing or operating the CP6930-RM. Kontron
assumes no responsibility for any damage resulting from failure to comply with these requirements.
WARNING
Due care should be exercised when handling the CP6930-RM. Be care-
ful, when removing or inserting the switch board, power supply, front
transition or fan tray. The boards may be very hot and should be
placed on any surface or in any form of storage container until such
time as the board and heat sink have cooled down to room tempera-
ture.
WARNING
Be careful when inserting or removing the CP6930. The SFP+ cages
have sharp edges which might lead to injuries
.
ESD Equipment!
Printed circuit boards contain electrostatically sensitive devices. Please observe
the necessary precautions to avoid damage to your board:
• Discharge your clothing before touching the assembly. Tools must be dis-
charged before use.
• When unpacking a static-sensitive component from its shipping carton, do
not remove the component's antistatic packing material until you are ready
to install the component in a computer. Just before unwrapping the anti-
static packaging, be sure you are at an ESD workstation or grounded. This
will discharge any static electricity that may have built up in your body.
• When transporting a sensitive component, first place it in an antistatic con-
tainer or packaging.
• Handle all sensitive components at an ESD workstation. If possible, use an-
tistatic floor pads and workbench pads.
• Handle components and boards with care. Don't touch the components or
contacts on a board. Hold a board by its edges or by its metal mounting
bracket.
• Do not handle or store system boards near strong electrostatic, electromag-
netic, magnetic, or radioactive fields.