D R A F T — F O R I N
T E R N A L U S E O N L Y
27
www.kontron.com
User Guide
CP6108X/CP6-GPU8860
4.4 MXM3.0 Module Installation
The CP6108X supports the installation of an MXM3.0 type A or type B module via the J11 connector. The
MXM3.0 module must be physically installed on the CP6108X prior to installation of the CP6108X in the
system. During installation it is necessary to ensure that the MXM3.0 module is properly seated in the
onboard connector J11, i.e. the pins are correctly aligned and not bent. Ensure that the module is
properly secured to the CP6108X.
The CP6108X equipped with an MXM3.0 module must be fitted with an appropriate heat sink to ensure
sufficient cooling. For MXM3.0 type A modules in conjunction with the CP6108X, Kontron offers a spe-
cifically designed heat sink solution. It is the responsibility of the system integrator to ensure that suf-
ficient cooling is provided when operating the CP6108X equipped with an MXM3.0 module. Please
contact Kontron for further information on suitable cooling solutions.
For information on the installation of the MXM3.0 module, refer to the documentation provided with
the module.
