21
www.kontron.com
User Guide
COMe Ref. Carrier-i T10 TNI
2.3.4 USB 2.0 Interfaces
The COMe Ref. Carrier-i T10 TNI supports eight high-speed USB 2.0 interfaces used as host by default:
»
USB#[0;1] are used for USB 3.0/2.0 double-stack connector, J9.
5V standby power for wake events may be enabled and disabled via the onboard DIP switch,
SW1.
»
USB#[2;3] are routed to the USB 2.0 double-stack connector, J13.
5V standby power for wake events may be enabled and disabled via the onboard DIP switch,
SW1.
»
USB#[4] is used for the Mini PCIe half-size interface to enable usage of USB 2.0 high-speed
Mini PCIe form factor devices.
»
USB#5 is used for the Mini PCIe full-size / mSATA interface to enable usage of USB 2.0 high-
speed Mini PCIe form factor devices.
»
USB#[6;7] are used for the USB 2.0 pin header, J10. USB#7 can be used as host or client
(switchable via the onboard DIP switch SW1).
The following figure and table provide pinout information for the USB 2.0 pin header, J10.
Note:
The USB 2.0 pin header, J10, is available as a standard feature on the COMe Ref. Carrier-i
T10 TNIV (Value) and the COMe Ref. Carrier-i T10 TNIP (Professional) versions.
2.3.5 USB 3.0 Interfaces
The COMe Ref. Carrier-i T10 TNI supports two super-speed USB 3.0 interfaces used as host:
»
USB_SS#[0;1] are routed to the USB 3.0/2.0 double-stack connector, J9.
2.3.6 HD Audio Interfaces
The COMe Ref. Carrier-i T10 TNI provides HD Audio via the industrial grade HD Audio Codec IDT / Tempo
Semi 92HD73C (U29) through the following analog and digital audio connectors:
»
Rear panel line-in connector, J22
»
Rear panel SPK / line-out connector, J23
»
S/PDIF header, J24
Figure 6: USB 2.0 Pin Header J10
1
7
10
2
J10
Table 8: Pinout of USB 2.0 Pin Header J10
PIN
SIGNAL
PIN
SIGNAL
1
Power
2
Power
3
USB6-
4
USB7-
5
USB6+
6
USB7+
7
GND
8
GND
9
--
10
NC